Nexø II – High-pressure test of the DPR system
Jacob Skov Larsen is here presenting the test of the DPR system (Dynamic Pressure Regulation) of the Nexø 2 rocket. This system is what sets it apart from Nexø 1. The system is an extra Read more…
Current Affairs GPS and FIDO Mads Wilson
This Current Affairs is about the GPS and FIDO system on the Nexø rockets. Mads Wilson tells about the setup and design.
Open House
Here is a short video from the open house at Copenhagen Suborbitals on the 12th of May. Thank you to everyone who showed up to see the Nexø 2 and ask us questions!
The complete story of Nexø 1
In the summer of 2016, Copenhagen Suborbitals launched one of the most advanced liquid fueled rockets built by a team of volunteer amateurs. Follow the team close up during final preparations for the launch and Read more…
A tribute to jet vanes
We have successfully launched two actively guided rockets, Sapphire and Nexø I. On both rockets, thrust vectoring was obtained through the use of jet vanes inserted into the engine exhaust. The jet vanes shown in this Read more…
Current Affairs – Jet Vanes – Guest Flemming Rasmussen
This video in the current affairs series is a walk through of the jet vane design and implementation on the Nexø II rocket by fabricator Flemming Rasmussen.
A short bulletin on the Nexø II rocket
Original blog by Jesper Rosendal. The pieces of the jigsaw puzzle we call Nexø II are about to be assembled. The pieces are a collection of aluminium parts, tubes, valves, wires, tanks, bolts, nuts and Read more…
The next month in Copenhagen Suborbitals
In this video we’ll take a closer look at the work going on beside the rocket: the planning and administration. Morten Bulskov will tell all about what is going to happen during the next month Read more…
The main cable harness for Nexø II
This vlog describes the main cable harness of the Nexø II. The harness is the interconnect between the various electronic subsystems, and also connects each subsystem to its various sensors and actuators.
The GPS board for Nexø II
The GPS board mentioned in my latest blog has now been put through the reflow soldering oven. Only component missing now is the GPS receiver from uBlox. As it cannot tolerate the reflow soldering process, Read more…
