In order to donate via bank transfer, we will send our bank account details to your email. Please enter your email address here:
Dear readers, CS has been placed in an extremely favorable situation, as our good friends from Danish Space Challenge have offered to donate one of their RIB boats to us. It is a Norsafe Mako Read more…
Well not yet but, Scott and Alex performed a checkout of the Nexø II onboard (stream) video cameras and the downlink connection. If everything works out on the day of launch, we will be able Read more…
Dear readers, A couple of weeks ago we performed a series of engine tests prior to the flight of Nexø II. In spite of a minor error, we approved the Engine Controller and its code Read more…
Dear readers, In the last couple of months, we have had a leaky rocket … It’s in the high-pressure system that there have been a few minor leaks. Most of the leaks have been found Read more…
Dear readers, On May 5, we tested our BPM5 engine in our test stand at our workshop in Copenhagen. The setup was a bit more audience-friendly this time and many had chosen to come by Read more…
Dear readers, Here’s a short update about the current activities in CS. A few weeks ago, we held the annual general meeting, which meant a little change in the board. Kristian Sørensen, who has been Read more…
Upgrade – Bolette, almost build for CS It’s happening – We can’t believe it…. The sun is shining and it’s above 5 degrees. Even though it has been cold, we have worked over the winter. Read more…
Dear readers! We have some great news from the rocket workshop. The work on our first “boilerplate” capsule is progressing with good momentum, despite the low temperatures of the season. I want to promote the Read more…
Dear readers, Our workshop is unheated, so we suffer a lot in the cold. Nevertheless, lots of things happens in the workshop as always, though it’s not all that looks like or is rocket science. Read more…
Dear readers, If you follow us on social media, you may have already discovered it, otherwise we will bring you some news. During the past week, we have made the first cuts and weldings for Read more…
