In an attempt to mitigate the spin we saw with our last manned Ballute jump, we made and tested a small-scale design, which is sown from two sections – top and bottom, rather than single continuous gores. This, we hope, allows better alignment of air intake pockets, which we expect caused the spin on the previous design.


Published by Rasmus Agdestein on

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Related Posts

Videos

See A Rocket Engine’s Fuel Consumption! It’s Amazing!

To characterize our BPM100 injector, we needed to go bigger than any other homemade project has gone before. The Spica rocket engine will burn through 50 liters of propellants each second. To simulate that on Read more…

Videos

Finding The Mass Flow of Rocket Fuel Injectors

After increasing the hole diameter of our swirl injectors, we need to confirm how that changes their mass flow. Jeppe guides you through how to do just that.

Videos

Our Homemade Reaction Control System Works!

After numerous leak tests and sealing tape applications, Adrian finally gets to see his reaction control system work.