One of the more delicate tasks in the workshop right now is the milling of the boxes containing the radio systems for Nexø II. The boxes contain the radio receivers and radio transmitters that enable us to send commands to the rocket, and receive telemetry data from the sensors on the rocket.


Published by Rasmus Ragdestein on

2 Comments

Tom · 16th July 2017 at 11:00 pm

Whats up all the cornball music? Do you even have intellectual property rights?

Hc Haagensen · 1st August 2017 at 6:06 pm

Fin video men drop pan fløjtene – dem der ser disse videoer elsker også lyden af maskiner

Leave a Reply

Your email address will not be published. Required fields are marked *

Related Posts

Blog

Data from our latest BPM-5 rocket engine test

Dear readers, On May 5, we tested our BPM5 engine in our test stand at our workshop in Copenhagen. The setup was a bit more audience-friendly this time and many had chosen to come by Read more…

Videos

A walkthrough of the Nexø II rocket (Part I)

The Nexø II rocket is up for launch this summer. In this video (Part 1 of 2 ) we walk you through the engine section of the rocket.

Blog

Spring is here

Dear readers, Here’s a short update about the current activities in CS. A few weeks ago, we held the annual general meeting, which meant a little change in the board. Kristian Sørensen, who has been Read more…