We have successfully launched two actively guided rockets, Sapphire and Nexø I.
On both rockets, thrust vectoring was obtained through the use of jet vanes inserted into the engine exhaust. The jet vanes shown in this video will be flown on Nexø II, planned to launch during the summer of 2017. As one jet vane is used for demonstration purposes, only three of the four jet vanes is shown mounted on the vane assembly.


Published by Rasmus Ragdestein on

2 Comments

Naeem ulfateh · 28th May 2017 at 9:03 am

You are doing wonderful.

Ibrahim · 21st June 2018 at 12:20 pm

Good job …………. what is specification of servo motors you are used ?

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Related Posts

Blog

T minus 6 days – we are go for launch of Nexø II 

We’re all very excited and we study the weather forecasts thoroughly. At the moment it’s only the weather that really can stop us. We are so ready to see Nexø II fly. The rocket is Read more…

Videos

A walkthrough of the Nexø II rocket (Part III)

The Nexø II rocket is up for launch this summer. In this video (Part 3 of 3 ) we walk you through avionics and parachute section of the rocket.

Blog

Nexø II Sea Acceptance Test

Dear followers, During the past weekend we performed what we call Sea Acceptance Test (SAT) of Nexø II and the entire launch system. It is a two day test where we set up all equipment Read more…